The engine is designed with electronic-throttle control for smooth operation, and a 180-amp alternator handles new lighting and other electronic functions. Daily maintenance is user friendly and the engine compartment is located at eye-level.Operators will also appreciate the new, larger 120-gallon fuel tank. It stores enough fuel to keep the machine working in the field all day, and the fuel fill is at ground level for ease and convenience.The all-new air system maximizes the harvest and cleaning of cotton. Airflow has been increased 20 percent to insure plenty of capacity for handling the cotton. State-of the-art aerodynamics testing was conducted to design this extremely efficient system. In-cab fan controls allow for convenient adjustment and monitoring.

Most light-duty cab/chassis have standard cab-to-axle (CA) dimensions: 60, 84, 108 and 120 inches. The CA is the distance from the back of cab to the center of the rear axle. Typically the 60-inch measure is used for a 10-foot body, 84-inch for a 12-foot body, 108-inch for a 14- or 15-foot body, and 120-inch for a 15- or 16-foot body.You can use a four-door, 4x4 cab/chassis up to the 84-inch CA, but beyond that you may run into an overload situation. Be very cautious with the larger 14- to 16-foot bodies, even with a two-door unit. Bodies are fabricated many different ways: formed or extruded construction; steel, stainless steel or aluminum; and varying thicknesses. All these things will have an effect on the weight of your body. Aluminum weighs approximately 40% less than steel or stainless steel, allowing for more equipment storage or personnel in the long run.

Though light in weight, Airbor magnetic drill has a powerful 1.6-hp air motor and 1,600-lb magnetic holding strength. With its extra rack, stroke length is extended to 10 1/4 in. Annular cutter capacity is up to 2 1/16 in. diam. Geared chuck adapter converts the unit to a standard drill press. The Slugger Air Force pneumatic drill, at 24 lbs, 6 1/4" high, is useful for confined area drilling. The drill''s features include a permanent magnet that turns on or off by air power, a cutter capacity of up to 1 1/16" diameter x 3/4" depth and the ability to use ShortSlugger cutters and frame cutters. These cutters'' geometry allows the operator to drill multi-layered truck frames in a single pass.

©2003 www.circular-saws.net All rights reserved.