dewalt circular saw |
circular saws | ||
 We have tons of quality circular saws for you to choose from. Find discount circular saws online right here and save a bundle when you buy from us. Chop saws online.* Reduces the size of the etched zone for improved cosmetics.Less EN time improves cleaning action to remove heavier oxidation, lessens penetration, and widens the bead profile.Inverter-based machines also let operators adjust welding-output frequency from 20 to 250 Hz. Decreasing frequency products a broader arc cone, which widens the weld-bead profile and better-removes impurities from the surface of the workpiece. It also transfers the maximum amount of energy to the workpiece, ideal for work requiring heavy metal deposition.Increasing frequency produces a tight, focused arc cone. This narrows the weld bead, helpful when welding in corners and on root passes and fillet welds. Independent amperage control of the EN and EP portions of the AC cycle allows the operator to fine-tune the amount of energy directed into the workpiece, as well as take heat off of the tungsten electrode. A basic, professional-quality AC GTAW power supply lets the operator adjust for variables: amperage, balance control, and shielding-gas pre-flow and post-flow time. HELIPORT: 60'' dia.STORAGE: Mud & Cmt Bulk--8,000 cf+5,000sks; Liquid Mud--1,400 bbl; Water forDrilling--8,500 bbl; Potable Water--1,400 bbl.DRILLING EQUIPMENT: Drawworks--Nat''l 1320;Pumps-two Nat''l 12-P-160 Triplex, 1,600 hp; Primemovers--five Cat. D-399; Rotary Table--37 1/2".BOP SYSTEM: 11", 15,000-psi BOP and manifold.CRANES: Three LeTourneau; 45-ton @ 25''.MOORING: Four 10,000-lb It anchors; four electricmotor driven winches rated at 50,000-lb pull each.POSITIONING: Thruster assist.SEA STATE: Operating draft--30''; Survival--wave height 50''. Though light in weight, Airbor magnetic drill has a powerful 1.6-hp air motor and 1,600-lb magnetic holding strength. With its extra rack, stroke length is extended to 10 1/4 in. Annular cutter capacity is up to 2 1/16 in. diam. Geared chuck adapter converts the unit to a standard drill press. The Slugger Air Force pneumatic drill, at 24 lbs, 6 1/4" high, is useful for confined area drilling. The drill''s features include a permanent magnet that turns on or off by air power, a cutter capacity of up to 1 1/16" diameter x 3/4" depth and the ability to use ShortSlugger cutters and frame cutters. These cutters'' geometry allows the operator to drill multi-layered truck frames in a single pass. ©2003 www.circular-saws.net All rights reserved. |
|