2 WASH siding to prepare it for painting. Begin with the wand''s nozzle 4 ft. from the house and slowly move it closer until you achieve the desired cleaning effect. Grip the spray wand with two hands, direct the water stream at a 45-degree angle to the siding and move the water stream constantly.3 CLEAN cars and other items with an accessory brush and detergent. First rinse the area with water, then switch to a detergent wash and finish with a rinse.4 SCOUR oil and dirt off a garage floor with a detergent: (1) Rinse surface dirt off the floor at high pressure. (2) Change the nozzle setting to low pressure to dispense detergent. (3) Finish by changing the nozzle back to high pressure and rinsing with water.

These systems generally consist of a GIS/GPS-based vehicle tracking system and the associated mapping display software. GIS, or Geographic Information System, provides the mapping component. With the tracker devices installed in vehicles, dispatchers can follow a vehicle''s location in real-time. When an incident occurs, controllers can quickly dispatch the vehicle nearest to the incident.In the El Paso Fire Department, for instance, the GPS-powered automatic vehicle locator system tracks the location of the department''s apparatus fleet. This system consists of a radio and a GPS receiver/transceiver affixed to each fire apparatus. A signal from the GPS unit is transmitted to a satellite, the signal bounces back to earth, and the radio system tells the computer system exactly where that unit is on a map to within one meter of accuracy.

Though light in weight, Airbor magnetic drill has a powerful 1.6-hp air motor and 1,600-lb magnetic holding strength. With its extra rack, stroke length is extended to 10 1/4 in. Annular cutter capacity is up to 2 1/16 in. diam. Geared chuck adapter converts the unit to a standard drill press. The Slugger Air Force pneumatic drill, at 24 lbs, 6 1/4" high, is useful for confined area drilling. The drill''s features include a permanent magnet that turns on or off by air power, a cutter capacity of up to 1 1/16" diameter x 3/4" depth and the ability to use ShortSlugger cutters and frame cutters. These cutters'' geometry allows the operator to drill multi-layered truck frames in a single pass.

©2003 www.circular-saws.net All rights reserved.